Space subsystems design: (navigation, control, structure and…)
Masoud Khoshsima; Mehran Shahryari ; Sajjad Ghazanfarinia; Shiva Emami; yaser saffar
Volume 16, Issue 2 , June 2023, , Pages 79-91
Abstract
The results show that the lidar in cold orbital conditions has a temperature increase of about 38 degrees Celsius due to thermal design. Also, the range of temperature fluctuations before applying thermal design in the cold state of temperature changes in a circuit is about 14 degrees and after designing ...
Read More
The results show that the lidar in cold orbital conditions has a temperature increase of about 38 degrees Celsius due to thermal design. Also, the range of temperature fluctuations before applying thermal design in the cold state of temperature changes in a circuit is about 14 degrees and after designing these fluctuations have been reduced to about 5 degrees. In hot conditions, the temperature conditions have improved a lot after the design and the maximum operating temperature is about 27 degrees the average temperature has decreased by about 22 degrees, while the temperature fluctuations have also decreased by 21 degrees. A significant temperature increase has occurred in the receiver after applying the thermal design in cold conditions, which is still within the allowed range. This is despite the fact that in hot conditions, after applying the thermal design, there was no significant change in the temperature of the receiver. In the case of the reflector, the conditions are completely different, so the minimum temperature in cold conditions has increased by 42 degrees and the maximum temperature has decreased by 7 degrees in hot conditions. In addition, temperature changes have become more uniform in both cases.
Space systems design (spacecraft, satellites, space stations and their equipment)
Amirhossain Adami; Mehran Nosratollahi; Hanieh Eshagh nia; Sajjad Kheirkhah; Shiva Emami; Ali Saadat dar; Narges Afsari; Khashayar Mashhadi; Mansour Hozuri
Volume 13, Issue 2 , June 2020, , Pages 63-77
Abstract
The CANSAT design, a simple and small scale of a satellite, is an experience for preparing for the design of a Life cycle of the space project. In this paper, the process of design and construction of ARTA CanSat, which is participated in the scientific-exploratory class of international competition ...
Read More
The CANSAT design, a simple and small scale of a satellite, is an experience for preparing for the design of a Life cycle of the space project. In this paper, the process of design and construction of ARTA CanSat, which is participated in the scientific-exploratory class of international competition in CANSAT Iran, has been written. The operation scenario is that an automatic scanner system, lands after releasing from 300 meters above ground level with using a recovery subsystem (parachute), which is controlled its downfall and landing position by the parachute controller system. During the descent, the data is transmitted by the sensors and sent to the ground station. After touchdown, the Hotwire system's operates and separates the parachute from the Rover section; Then CanSat with the moving on the ground by using the simpler section embedded underneath the structure, performing excavation while moving to the target point. Throughout the mission, the health of the biological payload is preserved.
